Set up a Curtain timer, wake up to natural light：
- Add your Curtain into SwitchBot App and click it.
- Choose 'More'.
- Click the 'Schedule'.
- Click '+' to add a new timer.
- Set up the Timer.
- Choose to Active or Close
After installing Curtain on Rod type curtains, if you feel tough to move curtains, you may need to try out installing the Grommet Kit, and here are some benefits:
1. Smoother for SwitchBot Curtain to push/pull drapes.
2. Work more efficiently.
For more detailed installation guideline, please watch the following video:
Grommet Kit Installation can make "incompatible" Rod curtain drapes work well：
As for the Grommet Kits, you need to install them with the plastic strip pulling as tight as possible. Try to reduce the number of the plastic hole between two plastic clips. See the picture below.
(In the picture, only leave 3 holes between each plastic clip so the Grommet Kits is installed pretty tight. Also, the Grommet Kits is recommended to install on the inner fold of the curtain drape so it will be invisible looking from the bottom up.)
When it is installed correctly, the eyelet on the curtain drape would always be staying in a relative verticle position to the rod. So when you open or close the curtain drape, it will fix the "stuck problems".
If you encountered this issue, please contact our support email. We'd like to help solve this issue ASAP!
How to calibrate curtains in three modes?
1. One SwitchBot Curtain - From Left to Right
Example Detail operations(left to right)
On the Open Mode page, select the direction you open your curtain and tap Go to Calibration calibrate properly, for example, if you choose Open from left to right.
Record the open position following the animation. Tap Move Right and Curtain will move continuously until you tap Pause. When you are done with recording the open position, tap Next. Record the close position following the animation. When you did, tap Next.
2. Two Curtains - from middle
Following the steps will help to calibration